![]() ![]() ![]() Then bending the prongs back straight again often resulted in them breaking off either then, or when bending back to secure the new board. That worked until you wanted to remove the board. These prongs were then bent over to hold the motherboard in place. Instead, there were metal "tines" or "prongs" that were punched out of the sheet metal where the motherboard mounting holes were. I note some old Dell systems didn't use standoffs or motherboard mounting screws. ![]() Click to expand.But even that can greatly limit upgrade options - depending on the case. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |